MIG welder HDC Kansas 350 (380 V 3~, 40-350 A, MIG/FLUX/MMA, synergy, euro connector)

Vendor code: HD-KNS350-E3

Characteristics

Wire diameter used: 0.8 / 1.0 / 1.2 / 1.6 mm

Network type: 3 phase

Open circuit voltage: 70 V

Rated input current: 19.8 A

Maximum input current: 25.5 A

Power factor: COS 0.92

Insulation class: H

Protection rating: IP21S

Weight (without accessories): 75.5 kg

Mains Frequency: 50/60 Hz

at At 20°C: 95%

at 40°C (EN 60974–1): 60%

Rated input voltage: 380V

MMA Welding Current: 40 A 21.6 V–350 A 34 V

Efficiency: 0.85

Overall dimensions (L x W x H): 840 x 320 x 1340 mm

Electrode diameter: 2.5–8.0 mm

MIG/MAG Welding current: 40 A 16 V–350 A 31.5 V

Warranty period: 12 months

Description:

Advantages:

■ 2-in-1: semi-automatic and manual welding

■ Microprocessor control 32-bit ST microprocessor based on ARM architecture

■ remote wire feed module with cable harness 5 meters long range

■ 4-roller wire feeder

■ Synergic and manual mode for MIG/MAG welding

■ Intensive work with wire up to 1.2 mm (in manual mode it is possible to use 1.6 mm in non-intensive mode)

■ Works with electrodes up to 8 mm in diameter

■ High duty cycle and efficient cooling for intensive work

■ Two displays for precise control of parameters

■ 2T4T modes,

■ Adjusting arc dynamics

■ 36V connector on the rear panel for connecting the gearbox heating

■ Gas purging after welding for additional protection of the weld seam

■ Transport wheels for easy moving of the welding station

■ Platform for carbon dioxide cylinder

Description:

Note! For ease of individualization of the welding machine, the welding torch is not included in the delivery package and must be purchased separately. The device is equipped with a universal EURO connector and can be equipped with any suitable burner. When working with 1.0 mm wire, it is recommended to use a torch of at least 25 series; when working with 1.2 mm wire, it is recommended to use a torch of at least 36 series. Inverter type welding machine for professional use. The device can be used both in semi-automatic welding mode and in manual electrode welding mode. The device is equipped with an external wire feed module with a 4-roller mechanism and a holder for spools with a diameter of up to 300 mm and a wire weight of up to 15 kg. 1.6 mm - only in manual mode. Synergy mode is not available.

Equipment:

+ Power supply

+ Wire feed module

+ Electrode holder with 3 meter cable

+ Ground terminal with 3 meter cable

+ Cable harness for connecting the power source and the wire feed module 5 meters

+ Gas hose 7 meters (as part of the cable harness)

+ Feed roller 1,21,6 mm - 2 pcs (installed in the wire feed mechanism)

+ Feed roller 0.81.0 mm - 2 pcs