Die grinder BULL EDG 6528 E (670 W, 8000-30000 rpm, 6 and 8 mm collets, soft start, constant electronics)

Vendor code: 1327858

Characteristics

Nominal voltage: 230 V

Nominal frequency: 50 Hz

Nominal power consumption: 670 W

Nominal speed: 8000-30000 rpm

Collet size included: 6.8 mm

Speed controller: Yes

Smooth start: Yes

Spindle neck diameter: 10 mm

Description:

Advantages:

■ Long-life, dust-protected 670 W motor

■ Intelligent motor control with effective cooling

■ Soft start, speed control, and constant electronics

■ Automatic brush ejection system

■ Universal 6 and 8 mm collets

Description:

The PSM is equipped with a long-life motor with full protection of the rotor and stator from abrasive dust. Reliable and time-tested NSK bearings are isolated from dust. The intelligent motor control board with an additional radiator for effective cooling ensures high comfort of use and a long service life of the tool. The PSM is equipped with all the necessary functions: soft start, speed control, constant electronics, overload protection. Automatic brush ejection when worn will not damage the motor collector and significantly extends the service life of the tool. 6 and 8 mm collets for different types of work make the tool universal. A highly efficient cooling system for the motor and control board allows the tool to operate in difficult conditions without overheating. The ventilation holes are partially located in the rear part of the body, which allows the air flow to pass freely through the entire tool system.

Equipment:

+ Open-end wrenches 2 pcs;

+ Collet: 2 pcs;

+ Carbon brush set - 1 set;

+ Operating instructions;