TIG welder SOLARIS TIG-200P (150–240 V~, 180 A, DC TIG, HF, Pulse, MMA)

Vendor code: TIG-200P

Characteristics

Input voltage: 150–240 V~

Network type: 1 phase

Open circuit voltage: 65 V

Rated input current: 20.8 A

Maximum input current: 38 A

Power factor: COS 0.87

Insulation class: H

Protection rating: IP21S

Weight (without accessories): 6.7 kg

Network plug included: no

Mains Frequency: 50 Hz

at 40°C: 30% (EN 60974–1)

at At 20°C: 60%

Rated power consumption at maximum current: 8.5 kW

TIG Welding Current (DC): 10–180 A

MMA Welding Current: 10–180 A

Ignition type: HF (high frequency)

Welding electrode diameter: 1.6–5.0 mm

Non-consumable TIG electrode diameter: 0.5–4.0 mm

Efficiency: 0.8

Overall dimensions (L x W x H): 400 x 160 x 280 m

Pulse Frequency: 0.5–150 Hz

Post-gas time: 2 s

Warranty period: 24 months

Description:

Advantages:

■ TIG HF DC Argon arc welding with non-consumable electrode direct current with high-frequency ignition

■ Pulse TIG mode suitable for welding thin metals

■ MMA mode allows the inverter to be used with conventional electrodes for manual welding

■ The device operates on 4 IGBT transistors, which makes it a reliable solution

■ High operating time of the device 60% at 20 °C

■ Stable operation in networks with reduced voltage (from 150 V)

■ 2T/4T mode

■ Down Slope: Continuously adjustable to avoid crater formation at the end of the weld.

■ Power cable 2 m (without power plug)

■ Noise filter to protect other devices from interference.

Description:

Note! The device is supplied without a plug. In case of operation at maximum currents, the device must be equipped with a 32 A 230 V single-phase power plug (not included). The Solaris TIG-200P inverter welding machine allows you to perform welding work in two modes: TIG - welding with a non-consumable tungsten electrode in a shielding gas (mainly argon) with direct current (DC) is used for welding any low-alloy or high-alloy carbon steel, including stainless steel, and heavy non-ferrous metals such as copper, nickel, titanium (except aluminum) and their alloys. TIG welding allows you to make neat, precise and small welds, which is difficult to achieve when welding with other modes. Pulse frequency mode: allows you to adjust arc concentration, arc width and penetration amount. This function is useful when welding thin metals. Down Slope Mode: Adjusts the time the current gradually decreases after welding is completed. Continuous adjustment avoids the formation of a funnel at the end of the weld. The arc is ignited using a high-frequency discharge (TIG HF), which facilitates the ignition process and significantly reduces wear and deformation of the electrode tip. The device is equipped with a 3 meter TIG torch. The TIG torch is equipped with a control key. MMA - classic welding with a manual coated electrode using an electrode holder. Simply switch the machine to MMA mode, connect the appropriate equipment, and use the device like a classic inverter for MMA welding. The TIG-200P welding machine is optimized for operation with reduced mains voltage from 150 V.

Equipment:

+ Welding current source;

+ Welding torch TIG 17 series 3 meters;

+ Electrode holder with 2 meter cable;

+ Ground terminal with 2 meter cable;